Mobile
Log In Sign Up
Home > english-chinese > "buffer amplifier" in Chinese

Chinese translation for "buffer amplifier"

缓冲放大器

Related Translations:
buffs:  磨光皮
buffed:  靡了面的
floor buffer:  楼板减振垫
load buffer:  装入缓冲区
area buffer:  面缓冲区
buffer casting:  缓冲弹簧座
spectral buffer:  光谱缓冲剂
door buffer:  门顶缓冲器
buffer lookaside:  监视缓冲器
buffer support:  缓冲器支承
Example Sentences:
1.An output buffer amplifier used in detection circuit of micro sensor
用于微传感器读出电路的输出缓冲放大器
2.Buffer amplifier section
缓冲放大部分
3.Every column in sensor array work in parallel and have their own cds noise reducing circuit . the signals after fpn reducing are output from the output buffer amplifiers
传感阵列中各列感光单元的传感信号并行输出,分别由对应的相关二次采样电路进行降噪处理,去除固定模式噪声后的信号通过输出缓冲放大电路进行输出。
4.If the node is at , or near to , ground then a grounded guard ring will be appropriate , if it is at some other potential it may be necessary to use a high input impedance buffer amplifier , with its input connected to the node , to force the guard ring to the node potential
如果被保护的节点的电位是(或接近)零电位,采用地线保护环最为合适;如果节点电位是其他值,那么可以用高输入阻抗放大器组成缓冲器,输入端连接该节点,输出端连接保护环。
5.Become a kind of new electronics circuit - current - mode circuit . it is replacing the traditional design method of the voltage - mode in the high frequency high - speed signal processing realm 。 this thesis mainly discussed the modified second - generation current conveyors based on the current - mode kinds of new cuicuit components , they are stronger modified standard current - mode parts in fuctions on this foundation . mainly including the modified differential difference current conveyor ( mddccii ) 、 the fully balanced second generation current conveyor ( fbccii ) 、 ( full balances ) four - terminal floating nullor ( fbftfn ) and the current differencing buffered amplifier ( cdba ) , they are all function very strong standard current - mode parts , they all can provide some circuit functions of better than general operation amplifier , because they have the voltage importation and the current importation , therefore use it since can carry out the voltage - mode signal processing circuit expediently , can also carry out the current - mode signal processing circuit expediently , and have to increase the benefit bandwidth to accumulate more widely than the voltage - mode , but have their advantages more according to the current - mode filter of the modified current conveyor , because it constitutes in brief , the filter wave function is stronger and they are better than in general use operation amplifier of many advantages , be easy to composing for example 、 high speed 、 frequency bandwidth 、 the power supply voltage requests low 、 consume small , the impedance is different from etc . advantages , otherwise they have biggish dynamic range , and flexible circuit synthesize , so they are the best active parts
从第二代电流传输器ccii入手,重点研究了以下几种改进型的第二代电流传输器:改进的差动差分电流传输器mddccii 、全平衡第二代电流传输器fbccii 、多输出四端浮地零器ftfn 、全平衡四端浮地零器fbftfn 、电流差分缓冲放大器cdba的电路结构及其模型。然后在此基础上系统地研究了基于这几种改进型的第二代电流传输器的滤波器的设计方法,主要方法和结果如下:利用mddccii设计了差分式连续时间电流模式低通、带通滤波器;电流模式跳耦结构考尔低通滤波器;利用fbccii设计了带通二阶节滤波器及电流模式双二阶通用滤波器;设计了基于多输出端ftfn的电流模式二阶通用滤波器电路;通过数字化开关选择的基于fbftfn的电流模式通用滤波器;设计了基于最少个数电流缓冲放大器(两个cdba )的多功能通用电流模式滤波器及其在非理想因素情况下分析。设计滤波器的主要方法是采用级联设计、运算模拟(信号流图法)和反馈设计(跳耦法) 。
6.The correlated double sampling ( cds ) circuits structure is used to reduce the fixed pattern noise ( fpn ) of the cmos sensors , and improve the signal - noise ratio ( snr ) . the 256 photodiodes arrayed 4 quadrants sensor consists 16x16 active photodiodes array . correlated double sampling processing circuits , output buffer amplifiers and digital control part
针对cmos制造工艺中mos器件固定模式噪声( fixedpatternnoise , fpn )较大的不足,研究中采用了相关二次采样( correlateddoublesampling , cds )电路降低固定模式噪声,从而提高了传感器的信噪比( signalnoiseratio , snr ) 。
7.The resonance network is connected to the gate , then the output and input matching network is designed to satisfy the oscillation criteria . then harmonic balance method is used to analysize and optimize the output power and phase noise . to minimize the load pulling effect a buffer amplifier is designed to isolate the oscillator and the load
本文在场效应管fet栅极上加上谐振网络(谐振网络是通过cst仿真得到的,它是串联反馈回路,介质工作在te01模,对于其后的fet ,它又相当于一个带阻滤波器) ,然后设计输入输出匹配电路,使电路结构满足起振条件,之后继续用谐波平衡法仿真和优化,使振荡器输出功率合适,相位噪声很低。
8.The electro - chemical measurement system used to perform dpsv measurement is constructed with two parts , a low - current measurement system consists of low input bias current operational amplifier and a high resolution sar adc and a potentialstat consists of high resolution dac and high current buffer amplifier
对于微分脉冲伏安溶出测量,我们使用高精度高速saradc和低偏置电流运放构成微电流采样系统,使用高精度dac和高速大电流缓冲放大器设计了恒电位计,并与微控制器共通组成电化学测量系统。
Similar Words:
"buffer address conter" Chinese translation, "buffer address register" Chinese translation, "buffer agent" Chinese translation, "buffer allocation" Chinese translation, "buffer amplification stage" Chinese translation, "buffer amplifier section" Chinese translation, "buffer and draw gear" Chinese translation, "buffer area" Chinese translation, "buffer arm" Chinese translation, "buffer assignment" Chinese translation